5. Auto Leveling
08
Power up the appliance and select “Leveling"
Default: After the printer has first automatically returned to the home position for auto-calibration, and after 16 points of data calibration, the printer will return
to the home position again and the levelling process is complete.
Go to “Prepare → Z-offset", adjust the Z-axis compensation value so that the height of the nozzle to the printing platform is about the thickness of a piece of
A4 paper (0.08-0.1mm); then, click the knob and the Z-axis compensation value is thus successfully determined.
0.08-0.1MM
5.1
5.2
0.00
Leveling
Leveling
To Next Page
Loading...
