Creality Ender-3 V2 Neo - First Printing Setup; Software Setup and Printer Selection; File Preparation and Slicing; G-code Generation and Printing

8. First Printing
13
8.1
Download from www.creality.com, or
find the Creality software on your
memory card and install it.
Creality Slicer
8.2 Go to Preferences → Basic → Select
Language → Finish to complete the settings.
8.3 Select the model of the printer
(Ender-3 V2 Neo).
8.4 Enter Parameters → Close.
8.5 Launch the
Creality Slicing
Software.
8.6 Load the file.
8.7 Select the file.
Creality Slicer
Load
8.9 Insert the memory card → Press the screen
knob → Select from the menu → Select the
used for printing.
8.8
Generate the G-code file → Save it to
the memory card.
The file name must only contain Latin letters and digits.
Chinese characters or special symbols must not be used.
Note: For details on using the software, please refer to the
slicing software user manual in the storage card.
Neo