Creality Ender - Step 22: Secure Wire Bundle; Step 23: Secure Motor Cable

13
22
Here we use the first zip tie to secure the heater and fan-hotend-wire bundle. Do not pull the wires
tight and make sure you do not damage them. Connect the NEMA motor cable supplied with the kit
to the motor – the connector at one end of the cable is wider than at the other end, use the widest
connector to connect to the motor. Do not force it in, the plug only fits in one orientation.
23
Use the next zip tie to secure the NEMA motor cable and the fan-hotend-wire bundle – again do not
pull the wires tight and make sure you do not damage them.