Firmware Updating
Security Statement
For the purpose of engraving or cutting with a laser engraving machine, allow the workpiece to be
exposed to the high-density laser beam emitted by the laser engraving machine. The workpiece may be
the machine breakdown and environmental contamination.
3. Clean the tripod and laser module with a dry cloth regularly when the power is off.
4. Ensure to run the laser at 0°C-35°C.
or stainless steel plate on the workbench, and then place processing material.
ãȉɍ٪ƤƇǾ٪ƫȉɦǾdzȉƇƫ٪ɅǕƲ٪dzƇɅƲȷɅ٪˚ȯǼɦƇȯƲ٪njȯȉǼ٪ǕɅɅȬȷؚإإɦɦɦؘƤȯƲƇdzǛɅɬƤdzȉɍƫؘƤǾإƲǾإȷȉnjɅɦƇȯƲع˚ȯǼɦƇȯƲإȉɅǕƲȯ؟ɅɬȬƲڏֿׄ٪
ؘ٪¯ƇɥƲ٪ɅǕƲ٪نؘƣǛǾه٪˚dzƲ٪ǛǾ٪ɅǕƲ٪ȯȉȉɅ٪ƫǛȯƲƤɅȉȯɬ٪ȉnj٪ɅǕƲ٪½F٪ƤƇȯƫؙ٪ƇǾƫ٪ƫƲdzƲɅƲ٪ȉɅǕƲȯ٪˚dzƲȷ٪ǛǾ٪½F٪ƤƇȯƫؘ٪UǾȷƲȯɅ٪ɅǕƲ٪½F٪ƤƇȯƫ٪ǛǾɅȉ٪ɅǕƲ٪
machine when powered off, and it will update automatically when powered on. The buzzer will sound during the
updating process. When the updating is completed, the sound will stop (do not power off during the updating
ȬȯȉƤƲȷȷخؘ٪Unj٪ɅǕƲ٪ǼƇƤǕǛǾƲ٪ǕƇȷ٪ƇdzȯƲƇƫɬ٪˛ƇȷǕƲƫ٪ɅǕƲ٪dzƇɅƲȷɅ٪˚ȯǼɦƇȯƲؙ٪ǛɅ٪ɦǛdzdz٪ǾȉɅ٪ɍȬƫƇɅƲ٪ƇǍƇǛǾؘ
To Next Page