6.2 Basic Operation
CAUTION
When switching on the power, make sure your hands out of reach of
such running parts as main shaft and
slider to prevent injury。
6.2.1 Start-up
6.2.1.1 Check whether the power is in OFF position。
6.2.1.2 Plug the cable into the receptacle of power source of the machine。
6.2.1.3 Make sure the power voltage is at usual level, press the power on/off. (when
starting up shaft X may pulse, so keep the slider some distance from reset switch. If
carrier hit reset switch, turn off the power and power it on again)。
ON
6.2.1.4 LCD in the control panel is on and displays the initializing process of the
host, and show following information：
PCUT- SV
CTS- 700
Ver 1. 50
00123456
On Li ne. . .
6.2.1.5 Initializing is over, the machine is in online state and connect able with the
computer to be operable。
6.2.2. Installation of cutting media
This machine is suitable not only single-sheet media, but also a roll of media。
Plotting servo machine PCUT S operating instructions PCUT SERIES USER
‘
S MANUAL
24
To Next Page
Loading...