What to do if Creation CT630 characters below 1CM are deformed?
If characters smaller than 1CM are deformed on the Creation Plotter, set an offset in the software, such as in “Wentai” sign software. Also, set the plotting speed of the cutter below 20.
Why can not the plotter run when it is outputting?
If the Creation plotter doesn't run during output, verify that it is properly connected to the computer and is in the online state. Also, check if the encryption card of the software is correctly inserted.
What to do if Creation CT630 paper deviates when it runs by a large margin?
If the paper deviates significantly when running the Creation Plotter, ensure the paper feed bracket containing the paper roll is completely parallel to the paperweight wheel. Loosen the bracket prior to plotting to prevent excessive obstruction. Use the two paperweight wheels at the sides instead of pressing all four down simultaneously.
Why do some nicks deep, while some shallow when cutting with Creation CT630?
When cutting with the Creation Plotter, if some nicks are deep while others are shallow, it may be because PCUT employs upscale soft PVC materials as a knife strip cushion to protect the knife. In this case, replace the stripe cushion. Additionally, adjust the knife as described in section 3.2.B and increase knife press to some 120-150.
What to do if the Creation Plotter is out of our control sometimes?
If the Creation Plotter is sometimes out of control, open the machine and properly plug in all the lines.
Why does zigzag happen to the Creation Plotter cutter?
If the Creation Plotter cutter experiences zigzag motions, adjust the speed according to the size of the character. Alternatively, set the speed to a specific size suitable for the characters being cut.
Why does the Creation Plotter first scratch a line before plotting?
If the Creation Plotter scratches a line before plotting, it is because the machine illegally escaped last time. Power off the machine and turn it on again to resolve this.
Why the machines have missed some pave of letter when cutting?
If the Creation machines have missed some pave of letter when cutting, check if the machine presses enough. Also, reinstall the software and check the head of the knife.
Why can not some characters close in strokes when Creation CT630 is plotting?
If some characters cannot close in strokes when the Creation Plotter is plotting, it is because the knife of the plotter is an eccentric knife with an eccentric value. Set “closing compensation” in the software.
Why is the Creation Plotter machine in low-speed state after start-up?
If the Creation Plotter machine is in a low-speed state after start-up, the paper sensor fails to detect the fore end of the paper. Perform the feeding paper action.
Explains symbols indicating potential hazards to life or equipment.
Explains symbols that draw attention or indicate forbidden actions.
Lists crucial safety instructions for machine operation and power handling.
Covers warnings and steps for connecting the machine and its accessories.
Details the procedure for fitting and adjusting the cutting tool.
Explains how to access system properties and device manager for COM port setup.
Describes how to select, disable, and access properties of COM ports.
Covers advanced settings for serial ports like baud rate and data bits.
Guides on performing a test cut to adjust knife pressure and protrusion.
Guides on adjusting and saving system parameters like speed.
Details how to adjust the downward force of the cutting knife.
Covers problems like extra strokes, zigzag cuts, and paper deviation.
To Next Page
General