Why there is an additional stroke after finishing cutting with Creation CT630?
If there is an additional stroke after finishing cutting with the Creation Plotter, check if the tip of the cutter is flexible when it is up and down. Also, change the Master software if there are some deviant letters and check if there are some problems on the files you are ready to output.
What to do if there is No LCD display or a black row of blocks are displayed on Creation CT630?
If there is no LCD display or a black row of blocks displayed on the Creation Plotter, check whether the power works well and whether the voltage is at the required level.
Why does the machine feel tingle?
If the machine feel tingle, make sure central line of the power source grounded.
Explains symbols indicating potential hazards to life or equipment.
Explains symbols that draw attention or indicate forbidden actions.
Lists crucial safety instructions for machine operation and power handling.
Covers warnings and steps for connecting the machine and its accessories.
Details the procedure for fitting and adjusting the cutting tool.
Explains how to access system properties and device manager for COM port setup.
Describes how to select, disable, and access properties of COM ports.
Covers advanced settings for serial ports like baud rate and data bits.
Guides on performing a test cut to adjust knife pressure and protrusion.
Guides on adjusting and saving system parameters like speed.
Details how to adjust the downward force of the cutting knife.
Covers problems like extra strokes, zigzag cuts, and paper deviation.
To Next Page
General