6.3.4 Raising knife, dropping knife
While in off-line state, press“DN” ,the knife will fall, then press“UP”to raise
the knife. When dropping the knife, it can passively cut common straight line and
square。
Press to
drop the knife
“”
Press to
raise the knife
“”
6.3.5 RESET
While the machine is working, press either button at both ends of the machine to
reset the machine, and the machine will reinitialize, the present position of knife top
will be set as new starting origin, all data in buffer memory will be cleared。
6.3.6 System parameters setting and storage
While in off-line state, press“MODE”to set system parameters, the LCD will display
the options of system parameters. Press “MODE”button to show the options in turn ,
press“+” or“-”to change the parameter value of selected option. When the setting is
completed, press“PAUSE”to escape setting mode, then press“TEST”in“Knifpress”
state to save the setting value。
PCUT SERIES USER
‘
S MANUAL Plotting servo machine PCUT S operating instructions
29
Press red button at both ends to
reset the machine.
To Next Page
Loading...