6.3.7 Compensation
6.3.7.1 When cutting, if some strokes are found not closing, so add closing
compensation function on carve drawing software (see the manual of software)。
Map:
Without compensation, not closing Compensation is suitable
6.3.7.2 When cutting, if right angles are not really 900, so add sharp-angle
compensation function on carve drawing software (note: compensation value shall be
decided to real error)。
Map:
Correct compensation Insufficient compensation Excessive compensation
When the output is done by using plotting software, high precision plotting
output is recommendable。
PCUT SERIES USER
‘
S MANUAL Plotting servo machine PCUT S operating instructions
35
To Next Page
Loading...