DigitalMedia Switchers Product Manual – DOC. 8418A
5. Check the status of the update. Refer to “Check Update Status” on page 43 for
instructions.
Set Day and Time
To set a specific day and time to update the firmware:
1. On the Auto Update Settings page, select the Set Day & Time button.
The Auto Update Settings - Set Day & Time page opens.
Auto Update Settings – Set Day & Time Page
2. Set the desired day (SUN, MON, TUE, WED, THU, FRI, or SAT) by clicking the
appropriate radio button, or click Every Day.
3. Set the time using 24-hour format in the hour and minute text boxes.
4. Click the Apply Settings button.
5. Click the Back button in the upper-left corner of the page to return to the Auto
Update page.
6. Check the status of the update. Refer to “Check Update Status” on the following
page for instructions.