Crestron DM-NVX-D30 - Page 25

Web Interface Configuration Guide — Doc. 8874D DM-NVX-D30/E30(C) • 21
DM NAX (AES67) Transmit
l
Mode: By default, the mode is set to Automatic which will add +1 to the outgoing video
stream multicast address. For example, if the Video multicast address is 239.8.0.0, the DM
NAX (AES67) Multicast address will be 239.8.0.1. The mode can also be set to Manual
(which will allow setting the multicast address in the field below) or Disabled.
l
Multicast Address: Sets the multicast address. This is only available when Mode is set to
Manual.
l
Port: Sets the port number. Available when Mode is set to Manual.
DM NAX (AES67) Receive
l
Multicast Address: Sets the multicast address.
l
Port: Sets the port number.
Under both DM NAX (AES67) Transmit Advanced and DM NAX (AES67) Receive Advanced are
the following options:
l
Auto Initiation: Toggle Auto Initiation to either enable or disable it. If disabled, the Start
and Stop buttons become available for use.
l
Status: Displays the status of the stream.
l
Encoding Format: Displays the encoding format of the stream.
l
Encoding Sample Rate: Displays the encoding sample rate of the stream.
l
Bitrate: Displays the bitrate of the stream.
l
Channels: Displays the number of channels.