Web Interface Configuration Guide — Doc. 8874D DM-NVX-D30/E30(C) • 1
Introduction
The DM-NVX-D30/E30(C) is a reliable compact decoder that supports HDR10 and HDCP 2.2 and
transports 4K60 4:4:4 video over standard Gigabit Ethernet with no perceptible latency or loss of
quality.
Web Interface Overview
The web interface of the DM-NVX-D30/E30(C) allows you to view status information for the
DM-NVX-D30/E30(C) and configure its network and device settings.
Access the Web Interface
The web interface is accessed from a web browser. The following table lists various operating
systems and the corresponding supported web browsers.
OPERATING SYSTEM SUPPORTED WEB BROWSERS
Windows® operating system Chrome™ web browser, version 31 and later
Firefox® web browser, version 31 and later
Microsoft Edge® web browser
macOS® operating system Safari® web browser, version 6 and later
Chrome™ web browser, version 31 and later
Firefox® web browser, version 31 and later
Operating System and Supported Web Browsers
To access the user interface, do either of the following:
l
Open it directly in a web browser.
l
Open a web browser from within the Crestron Toolbox™ application.
Access Web Interface with a Web Browser
1. Enter the IP address of the DM-NVX-D30/E30(C) into a web browser.
NOTE: To obtain the IP address, press the Setup button on the front panel of the DMF-
CI-8 chassis of the DM-NVX-D30/E30(C). The IP address will appear on a display
connected to the HDMI® output.
To Next Page
Loading...
