Crestron DM-NVX-E30 - Physical Description; DM-NVX-E30 and DM-NVX-D30

2 • DM-NVX-E30(C)/DM-NVX-D30(C) Encoders/Decoders Product Manual – DOC. 8425A
Physical Description
The following sections provide information about the connectors, controls, and indicators
that are available on the DM-NVX-E30(C) and DM-NVX-D30(C) devices.
DM-NVX-E30 and DM-NVX-D30
This section provides information about the front and rear panels of the DM-NVX-E30
and DM-NVX-D30.
Front Panel, DM-NVX-E30
The following illustration shows the front panel of the DM-NVX-E30.
DM-NVX-E30 Front Panel
 CONSOLE: Micro USB connector, female;
USB 2.0 computer console port for setup
 NV LED: Green LED, indicates that the device is encoding (transmitting)
network video
 OL LED: Green LED, indicates an online connection to a control system via Ethernet
 LAN: 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port;
1
PoE+ PD (powered device) port compatible with a PoE+ compliant Ethernet switch, a
Crestron DM-PSU-ULTRA-MIDSPAN, or an approved third-party PSE;
Green LED indicates Ethernet link status;
Amber LED indicates Ethernet activity
 HDMI INPUT LED: Green LED, indicates sync detection at the HDMI® input
 HDMI INPUT: HDMI Type A connector, female;
HDMI digital video/audio input (DVI and Dual-Mode DisplayPort™ interface
compatible)
2, 3
1
The LAN port must connect to a 1000BASE-T switch in order to stream network video.
2
The HDMI connection requires an appropriate adapter or interface cable to accommodate a DVI or
Dual-Mode DisplayPort signal. CBL-HD-DVI interface cables are sold separately.
3
Device control via CEC (Consumer Electronics Control) requires the use of a Crestron 3-Series® or later
control system.
    

