Crestron DM-RMC-100-STR - Configuring On-Screen Display Settings; Configuring Text Overlay Settings

Supplemental Guide – DOC. 7846A DM-RMC-100-STR: HD Streaming Receiver
•
11
Configuring On-Screen Display Settings
On-screen display settings can be configured to allow text or an image—or both—to be
overlaid on the connected display. Text can be overlaid for purposes such as labeling the
video or displaying instructions, schedules, or alerts. An image such as a logo graphic can
be overlaid to allow branding of the streaming content.
To enter and configure text for on-screen display, refer to “Configuring Text Overlay
Settings” below. To select and configure an image for on-screen display, refer to
“Configuring Image Overlay Settings” on the following page.
Configuring Text Overlay Settings
To configure text overlay settings, do the following:
1. In the navigation bar, click
On-Screen Display
. The On-Screen Display page
opens.
On-Screen Display Page—Text Overlay
2. In the
Text Overlay
section of the page, do the following:
a. Enable text overlay by clicking the
Enabled
radio button if it is not already
selected. By default, the
Disabled
radio button is selected, preventing text
from being overlaid for on-screen display.
b. In the
Text to display
text box, enter the desired text.
c. In the
Location
drop-down list, select one of the following options to
position the text on the display device:
Custom, Upper Left
(default
setting),
Center Left, Lower Left, Upper Right, Center Right,
or
Lower
Right
.
If
Custom
is selected, enter the
X
(horizontal) and
Y
(vertical) coordinates in
pixels to position the text on the display.
d. In the
Font Size
drop-down list, select one of the following options:
•
Custom:
(Default setting) Allows a custom point size to be set in
the
Font Size
spin box
•
Small:
Sets a fixed point size of
22