Crestron DM-RMC-100-STR - Restoring Factory Default Settings; Rebooting the DM-RMC-100-STR

20
•
DM-RMC-100-STR: HD Streaming Receiver Supplemental Guide – DOC. 7846A
c. Click the
Load
button. A message appears, indicating that the
DM-RMC-100-STR will reboot.
d. Click
OK
to reboot the device.
• If the
Use service port
radio button is selected, do the following:
a. Insert a USB mass storage device containing the firmware file into
the USB port of the DM-RMC-100-STR.
b. Click the
Load
button. A message appears, indicating that the
DM-RMC-100-STR will reboot.
c. Click
OK
to reboot the device.
Restoring Factory Default Settings
To restore factory default settings, do the following:
1. In the navigation bar, click
Device
. The Device page, which includes a
Device
Management
section, opens.
Device Page—Device Management, Restore
2. Click the
Restore
button. A message appears, indicating that all default settings will
be restored and that the device will reboot.
NOTE:
Clicking the
Restore
button restores all settings—including the network
settings—to the factory default settings. If a static IP address is set, clicking the
Restore
button reverts the IP address to DHCP mode, which is the factory default
IP address setting (refer to “
Configuring Network Settings” on page 16).
3. Click
OK
to restore factory default settings and to reboot the device.
Rebooting the DM-RMC-100-STR
To reboot the DM-RMC-100-STR, do the following:
1. In the navigation bar, click
Device
. The Device page, which includes a
Device
Management
section, opens.
Device Page—Device Management, Reboot
2. Click the
Reboot
button. A message appears, indicating that the device will reboot.
3. Click
OK
to reboot the device.