Crestron DM-RMC-100-STR - Page 17

Supplemental Guide – DOC. 7846A DM-RMC-100-STR: HD Streaming Receiver
•
13
2. In the
Image Overlay
section of the page, do the following:
a. Enable image overlay by clicking the
Enabled
radio button if it is not
already selected. By default, the
Disabled
radio button is selected,
preventing an image from being overlaid for on-screen display.
b. Specify the image path type by selecting the
Local
or
Remote
radio
button:
• If the image is located on the hard drive of the device from which
the DM-RMC-STR-100 user interface is accessed, select
Local
.
• If the image is located on a device other than the local hard drive,
select
Remote
.
c. Specify the path to the image as follows:
• If the image path type is set to
Local
, click the
Browse…
button,
navigate to the desired image file, and then click
Open
. The image
file is uploaded from the local device to the DM-RMC-100-STR.
The filename appears in the
Browse…
box.
• If the image path type is set to
Remote
, enter the URL (HTTP,
HTTPS, or FTP), and then click the
Set
button.
d. In the
Location
drop-down list, select one of the following options to
position the image on the display device:
Custom, Upper Left
(default
setting),
Center Left, Lower Left, Upper Right, Center Right,
or
Lower
Right
.
If
Custom
is selected, enter the
X
(horizontal) and
Y
(vertical) coordinates in
pixels to position the image on the display.
NOTE:
Using SIMPL programming, transparency can be set for the entire image.
In addition, an image can be loaded dynamically.