Crestron DM-RMC-100-STR - Page 19

Supplemental Guide – DOC. 7846A DM-RMC-100-STR: HD Streaming Receiver
•
15
If
Custom
is selected, select the desired underscan percentage in the
Underscan
spin box by clicking the up or down arrow until the desired percentage is displayed.
Valid values range from
0
to
10
in one-tenth intervals (for example, 0, 0.1, 0.2, 0.3,
and so on). Click the
Set
button to save the setting.
5. Enable or disable automatic timeout by selecting the
Enable
or
Disable
radio
button, respectively. By default, automatic timeout is disabled.
If automatic timeout is enabled, select one of the following options in the
Timeout
drop-down list:
Custom, 1 minute, 5 minutes
(default setting),
10 minutes,
or
15 minutes
.
If
Custom
is selected, select the desired automatic timeout value in the
Timeout
spin box by clicking the up or down arrow until the desired timeout value is
displayed. Valid values range from
0
to
300
in one-tenth intervals (for example, 0,
0.1, 0.2, 0.3, and so on). Click the
Set
button to save the setting.
The HDMI Output page displays information about the connected display device in the
Connected Display
section of the page.
HDMI Output Page—Connected Display Information
As shown above, the following information is displayed:
•
Sink Detected:
Specifies whether the HDMI signal is detected by the connected
display (
Yes
or
No
)
•
Transmitting:
Specifies whether the HDMI output is transmitting an HDMI signal to
the connected display (
Yes
or
No
)
•
Current Resolution:
Specifies the current resolution of the connected display
•
Manufacturer:
Specifies the name of the manufacturer of the connected display
•
Name:
Specifies the model name of the connected display
•
Serial Number:
Specifies the serial number of the connected display