Crestron Isys™ TPS-6000 15 Inch Tilt Touchpanel
The default is none. If the keyclick option is selected, this WAV file
becomes the default keyclick sound for all buttons. The other WAV
files can be played by having the SIMPL Windows program assert the
assigned join number.
2. Each WAV file must have the correct audio format and attributes for
the TPS-6000 target type selected in VT Pro-e. The correct audio
format is PCM, 8, 11, 16, 22, or 44kHz, mono or stereo, 8 or 16 bit.
3. There are three system-wide join numbers that the designer can define.
The first, sound playing from panel, differs from the other two in that it
is triggered from the panel.
a. Sound Playing from Panel – The signal for this join number goes
high when the WAV file plays.
b. Mute Sounds – All WAV files (except the keyclick) in the project
are muted when this join number goes high.
c. Mute Key Click – The keyclick sound is muted when this join
number goes high.
Using Sound Manager
Sound Manager is broken into two distinct components. The Project Audio Joins
component, shown below, permits the designer to assign the three system-wide join
numbers described in the previous section. The three system joins can be assigned
automatically with the Auto button or by scrolling down to the desired number.
Project Audio Joins Component
The Sound List component, shown below, permits the designer to attach WAV files
to the touchpanel project. Complete the following steps to attach (add) a WAV file.
Sound List Component
1. Use the Browse button to locate the desired WAV files. It should
appear in the field adjacent to the Browse button.
2. If necessary, select the Play button to verify that the file in the browse
field is the desired file.
Operations Guide - DOC. 5864A 15 Inch Tilt Touchpanel: Crestron Isys™ TPS-6000 • 31
To Next Page
Loading...
Need help?
General
