Crestron TPMC-8X-GA User Manual

Crestron TPMC-8X-GA Isys
®
8.4” WiFi Touch Screen
Appendix: TPMC-8X-GA Security Pack
In some situations, such as when your wireless access point is connected to a
RADIUS (Remote Authentication Dial In User Service) server, authentication is
required before network access is granted.
In order to gain access in this infrastructure, a username and password must be
entered for verification by the server. To facilitate this, the TPMC-8X-GA Security
Pack adds the Atheros Client configuration utility.
The Security Pack is available as a special firmware build
(TPMC-8X-GA_SP_1.4.zip or later) for the TPMC-8X-GA. For details on how to
upgrade firmware, refer to “Programs, Projects and Firmware” which starts on page
47.
NOTE: The TPMC-8X-GA Security Pack is only needed if authentication is
required by the server with which your wireless access point communicates. If
authentication is not required, Crestron recommends that you do not install this
package. Once installed it cannot be removed without sending the TPMC-8X-GA
back to Crestron.
To begin the authentication process for your wireless access point, touch AP in the
“Ethernet Setup” window. (Refer to illustration on page 28.) The “Atheros Client
Utility” window will open.
“Atheros Client Utility” Window
Touch the Profile Management tab.
Operations Guide – DOC. 7078C Isys
®
8.4” WiFi Touch Screen: TPMC-8X-GA • 55

Crestron TPMC-8X-GA Specifications

General

Brand	Crestron
Model	TPMC-8X-GA
Category	Touchscreen
Language	English