Crestron TS-1070 User Manual

Product Manual — Doc. 8555F TS-70 Series • 73
Touch the screen to display the main Setup screen (TS-1070 shown).
Device settings for the touch screen may be configured using the built-in setup screens or the
web configuration interface. For more information on configuring the touch screen, refer to
Configuration (on page81).
Access the Device Setup Screens
To access the built-in setup screens, place five fingers on the display and hold for 15 seconds.
Use the setup screens to configure various settings for the touch screen, including Ethernet
setup, IP table setup, audio setup, display setup, standby timeout, application selection,
diagnostics, and the virtual toolbar.
Access the Web Configuration Interface
The touch screen provides a web configuration interface that is used to view and configure
various touch screen settings and to select an application. The interface can be accessed using
the touch screen IP address.
To access the web configuration interface using the touch screen IP address:
1. Ensure that the touch screen is connected to the network.
2. Use the Device Discovery tool in Crestron Toolbox™ software to discover the touch screen
and its IP address on the network.
3. Enter the touch screen IPaddress into a web browser.

Crestron TS-1070 Specifications

General

Resolution	1280 x 800 pixels
Touch Technology	Projective capacitive
Power over Ethernet	Yes
Wi-Fi	Yes
Camera	No
Microphone	Dual, front-facing
Ethernet	10/100/1000 Mbps
Bluetooth	No
Speakers	Yes
Operating System	Android™ 9
Processor	Quad-core
Memory	2 GB RAM
Storage	16 GB Flash
Connectivity	Ethernet, Wi-Fi
Display Size	10.1 inches
Mounting	Wall or Tabletop
Power Supply	PoE