Croozer Cargo - Unfolding the Croozer Cargo

To Next Page

To Previous Page

CroozerCargo14-ENG-2-14

Initial Assembly and Unfolding the Croozer Cargo

Unfolding the Croozer Cargo

1. Place the folded Trailer on a clean and stable surface.

2. Pull up the two side panels (1).

3. Pull the rear frame tube (2) towards the back and

press it into the clips (3) on both sides until you hear

and feel it snap into place.

4. Pull the front frame tube (4) forwards and press it into

the clips (5) until you hear and feel it snap into place.

RISK OF PINCHING OR CRUSHING! There are pinch

points between the clips and frame tubes, that may cause

painful injuries. Use caution to avoid these points when

folding or unfolding the trailer.

Tip: A new Croozer Cargo will be slightly more difficult to

unfold because the canvas is still stiff.

5. Check that the front and rear frame tubes (2 and 4)

are snapped fully into the clips on both sides (3 and

5) by pulling the two frame tubes inwards with gentle

pressure. There should be no movement in the frame

tubes when you press against them.

If the frame tubes are not snapped securely into the clips,

the frame of the Croozer Cargo could collapse while rid-

ing.

6. To fold the Trailer, follow these instructions in the

reverse order. Remove the cover and pull the frame

tubes out of the clips (3 and 5 on both sides).