Croozer Cargo - Croozer Cargo Handcart Conversion; Installing the Handcart Wheel

14
CroozerCargo14-ENG-2-14
Converting the Croozer Cargo to a Handcart
Converting the Croozer Cargo to a
Handcart
To convert the Croozer Cargo to a Handcart, a Handcart
wheel is mounted on the hitch arm, and a handlebar on the
rear of the Croozer Cargo.
Installing and removing the Handcart wheel
1. Lift the hitch arm.
2. Open the wire loop of the security pin (1) on the
Handcart wheel socket (3) or the hitch connector, and
remove the security pin (1).
Tip: Apply some silicone spray to the swivel stud of the
Handcart wheel to reduce friction and help the wheel
turn more easily.
3. Insert the Handcart wheel (2) into the Handcart wheel
socket (3) on the hitch arm.
4. Push the security pin (1) through the hole in the Hand-
cart wheel socket (3).
5. Snap the wire loop (4) of the security pin over the pin
end protruding from the other side of the socket to lock
it into place.
Always check that the wire loop of the security pin is
snapped securely onto the pin end. If the security pin
is not securely locked, the Handcart wheel could fall off
while in use, potentially damaging the hitch arm.
6. To remove the Handcart wheel, follow these steps in
the reverse order.
After removing the Handcart wheel, be sure to lock the
security pin back into the hole in the Handcart wheel
socket (3) or in the hitch connector (5). Never leave the
security pin hanging freely from its strap! It could get
caught on passing objects and be pulled off, damaging
the vehicle.
5
1
2
3
ClosedOpen
4
1
3
5
3
5