Crown DCi 8 - Software System Configuration: Bridge Mode Output; Bridge Mode Output Wiring and Settings

DriveCore Install Network Display Series Power Amplifiers
page 23
Operation Manual
Software System Conguration
Bridge Mode (16, 8, or 4 Ohm) Output Operation
Typical input and output wiring, along with software settings are
shown in Figures 22 and 23.
INPUT WIRING: If using analog inputs, it is only necessary to wire
the odd number inputs.
OUTPUTS: Connect the speaker across the positive terminals of
each channel pair. Do not use the negative terminals of
the channel pair when the pair is being operated in Bridge-Mono
mode.
Figure 22 System Wiring Bridge Mode
Figure 23 The bridge mono checkbox must be checked for proper operation
Always route the input and output wires in separate bundles.