CoCo-80 Quick Reference
66
menu. The frequency, and peak amplitude of several
steady state waveforms can be specified, as well as start
and end frequencies for sweep and chirp outputs.
Select a waveform using the Up and Down arrow keys and
press the Right arrow key to adjust the output parameters
of that waveform. Press F4 (Enable) to toggle the output
on or off.
Figure 67: Output Channel setup
The Tacho/RPM settings specify how RPM will be
handled.
Apply the user expected RPM value set by PC:
applies a standard RPM value estimate to the
measurement.
Prompt to let user manually input the value: Allows
input from a measured tachometer readout.
Read from the Tachometer measurement: uses the
instantaneous speed read from an external
tachometer instrument.
To Next Page
Loading...
