OPERATION
Page 4-1
USB Port
EZT-570S Tilt Screen
Figure 1. CSZ EZT- 570S Controller
START-UP INSTRUCTION SUMMARY (EZT-570S CONTROLLER)
The control section, illustrated in Figure 1, is composed of a CSZ EZT-570S
Controller. Specifi cations for the Controller may be found in the EZT-570S User's
manuals, located on the digital media included in this binder.
When running at high
humidity levels for an
extended period of time, the
tip of the humidity sensor can
become saturated, resulting
in erroneous readings. To
correct this condition, it is
recommended that the tip
be dried out by turning the
humidity system off and
raising the temperature to
250ºF (121.1°C) high temp
for 10 minutes. The sensor
accuracy will be restored by
evaporating the water out of
the porous cover over the
sensing element.
Humidity performance will
be affected if live loads are
placed in the chamber when
trying to achieve certain
humidity levels.
NOTE
NOTE
Any changes to the CSZ
confi gurations programmed
in the temperature controller
or safety limit without prior
authorization by CSZ could
void warranty. Related
issues and costs associated
from the changing of these
confi guration settings could
be deemed customers
responsibility. Call factory
prior to changing these
confi gurations.
NOTE
Note: CSZ is continuously upgrading the components used
in its equipment. Consequently, the physical appearance of
certain components may vary from that shown.
To Next Page
Loading...
