CTI 2572-B / 2500C-2572-B Installation and Operation Manual 81
PLC CAMP Client Error Codes
The remote device does not support the IP
protocol you are requesting.
The protocol may have been disabled in the
startup options of a remote 2572 or 2572-A
module. Check the remote device.
Check the network address in the command
block. If you are using a PC to emulate a PLC
server, ensure that the network parameters
SOCKET TYPE NOT SUPPORTED
The remote device does not support the
socket type you are requesting.
See the previous solution.
The 2572-B cannot obtain the network
address.
This may occur when there is a general
problem on the network. Check the network
address you have specified in the command
block. Correct if necessary. Retry the
operation. If the problem persists contact
your network administrator.
The 2572-B cannot assign the requested
See above. If the problem persists contact
CTI.
The network you are attempting to use is
down.
This may occur when you are attempting to
connect to a remote on another network via
a router and the network has been taken out
of service.
First, make sure that you have specified the
correct IP address. Retry the operation. If the
problem persists, contact your network
The network you are attempting to use is
unreachable.
You have specified a network address for a
network that cannot be found. This probably
occurred because you specified an incorrect
IP network address. Check the entry in the
command block and retry.
If you believe that you are using the correct
network address, contact your network
NETWORK CONNECTION ABORTED
The remote device (host) aborted the
connection.
This may occur if the remote host
encountered a problem with TCP data
transmission where recovery was not
possible. You should attempt to create the
connection again. If the problem persists,
CONNECTION RESET BY PEER
The remote device has reset the connection.
To Next Page
Loading...