CTI 2572-B / 2500C-2572-B Installation and Operation Manual 83
The receiving device detected a bad or
missing delimiter in the command message
This error usually indicates a transient error
in the data link. You should retry the
command.
If the receiving node is a computer simulating
a 2572-B PLC server, ensure that the
software is correctly processing the message.
If the error persists contact CTI.
BAD BLOCK CHECK CHARACTER
The receiving device detected a block check
character error in the command message.
The receiving device reported an invalid TYPE
character in the message.
The receiving device reported an invalid data
character. Only characters 0-9 and A-F are
The receiving device reported an odd
number of characters in the message. All
CAMP messages have an even number of
The receiving device reported an invalid
device code in the message.
The 2572-B detected an invalid device code
in the response from the remote device
This error may result from a transient error in
the data link. You should retry the command.
If the problem persists, check the quality of
the data link.
If the remote node is a computer simulating a
2572-B PLC server, ensure that the software
is correctly creating the response the
The 2572-B detected a missing delimiter in
BAD BLOCK CHECK CHARACTER
The 2572-B found a bad block check
character in the response message.
The 2572-B detected an invalid TYPE
character in the message sent from the
To Next Page
Loading...