www.ctronicssecuritycameras.com
10
Can set stay time for preset position as 5 to 60 Seconds when the IR dome camera
auto tour 。 operation method by controlling keyboard, DVR to implement the
command “call No.123 preset position”，the stay time add 5 sec；“call No.124 preset
position”，the stay time minus 5 sec；Stay time setting command for auto tour
reference table 6.
Table 6： preset stay time and preset relation table
stay time operation
default 10 sec
Call No.106 clear all Settings to restore the default
Add 5 sec Call No.123 preset
Minus 5 sec Call No.124 preset
Example: using a type of controlling keyboard to set the stay time be 8 sec
a、Press the key “call preset position”, then enter “123”
b、Press “ enter”
Remark ：If the preset position come to off normal after long time of auto tour
or outside force, restart the the dome to recover normal state
（3）Clear cruise routes
Call No.106 clear all Settings to restore the default
3、Limit scanning on left and right、355°Horizontal scanning、pattern scan.
By the controlling keyboard or DVR related command execution,you can setting or
calling Limit scanning、355°Horizontal scanning、pattern scan.
（1）Limit scanning on left and right setting
By controlling keyboard or DVR to implement the command “set No.83 preset
position” after moved the dome to the right for the required position ，Implementing
the command “set No.84 preset position” after make the dome rotating to the left
to the position of left limit position, left and right limit position is setting done.
Now, the dome just running between these two points only.
Tip: left and right limit setting and invoke the command relationship between
scanning the corresponding table 7.
Example: use a type of controlling keyboard to set limit position on left and right
To Next Page
Loading...
Need help?
General
