www.ctronicssecuritycameras.com
6
3、IP dome signal of the camera and power cable connection please reference
chart
Ⅴ:Address, Protocol, Baud rate setting
Integrated High Speed Dome Camera built-in decoder .You can setting the
address, the Protocol and the baud rate are adaptive. This product designed the
dial switch located on the sphere, given the set of convenient and stability,
there is a piece of gusset plate under the ball cover which can open and close at any time.
Open the gusset plate can see an 8-bit dial switch.1-8 of dial up used to set address
code of the dome.
１、Address setting
No.1~ No.8 are use to set the address codes of the bits dial switch, you can set
address codes within the range 1~255, factory default as 1. Use binary, dial every
number to be "ON" is means as 1, dial to be "OFF" is means as 0, details please
reference the sheet 2.
Address codes and dial codes switch sheet (Binary), calculate it according to
this sheet：
Binary Add
To Next Page
Loading...
Need help?
General
