Need help?Do you have a question about the CTX MyPool pH and is the answer not in the manual?
General| Category | Water Pump |
|---|---|
| Type | pH Controller |
| pH Accuracy | ±0.1 pH |
| Protection | IP65 |
| Model | CTX MyPool pH |
| Power Supply | 230V AC, 50Hz |
| pH Measurement Range | 0.0 - 14.0 pH |
| Temperature Compensation | Automatic |
Secures PSS3 onto 2" hose ($\phi$=50 mm).
Foot filter with PP riser.
Mounting bracket kit with $\phi$=6 mm screws.
FPM Lip valve for 3/8" GAS connection.
PSS3 probe-holder for 1/2" GAS connection.
pH probe for measurement.
Redox probe for measurement.
pH 7 buffer solution for calibration.
pH 9 buffer solution for calibration.
475 mV calibration solution for ORP.
Water for rinsing.
4m of 4x6 mm IDxOD PVC tubing.
5m of 4x6 mm IDxOD PE tubing.
Reducer from 1/2" M to 3/8" F for injection valve.
Position probe perpendicular to tubing, not exceeding 45° from vertical.
Visual representation of the installation setup.
Illustrates connections for power supply, probes, and relays.
Procedure to adjust the set point value using buttons.
How to activate and exit the unit's stand-by mode.
Instructions for priming the pump while in stand-by.
Displays current measurement, temperature, and alarm status.
Step-by-step guide for pH calibration using buffer solutions.
Steps for calibrating pH using an external reference.
Step-by-step guide for ORP calibration using buffer solutions.
Steps for calibrating ORP using an external reference.
Details common alarms and recommended corrective actions.
Procedure to reset the unit to its default factory settings.
Step-by-step guide for replacing the pump's hose.
Wiring instructions for connecting to the Connect & Go cabinet.
Wiring instructions for connecting to the Connect Box.
Procedure to select the user interface language.
How to activate or deactivate the RS485 communication menu.
Setting the communication speed for RS485.
Selecting the communication parity for RS485.
Setting the equipment address for RS485 communication.
Adjusting the value for the RS485 watchdog timer.
To Next Page
