24 ADJUSTMENT
Separate choke type
Throttle Cable Installation, Adjustment
• Link the thmltle cable (G) to the speed control
lever(C) and looselyclampthe throt!lecable outer
housing (F) wr_ the cable clamp bolt (A).
• Move the throttle lever to =FAST" position.
• Pull up the outer housing (F) of the throttle cabre
untilthe inner wire {G) has elmost no slack, and
tighten the cable clamp bolt (A).
• Move the throttle lever to =stow"position. Make
sure thatthe carburetor throttlevalve (H} ismoved
smoothly.
Choke Cable Installation, Adjustment
• Link the choke cable (K) tothe choke control lever
(D), and Ioose|y clamp the choke cable outer
housing (L) with the cable clamp bolt (B).
• Move the equipment choke controlto =OPEN" po-
sition. Make sure that the carburetor choke valve
(M) is fully opened.
• Pull up the outer housing (L) of the choke cable
until the Inner wire (K) has almost no slack, and
tightenthe cable clamp bolt(B).
• Move the equipment choke contro| to "CHOKE"
position. Make sum that the carburetor choke
valve (M) iscompletely closed.
• Make sure that the choke valve turns from fully
dosed positionto fully opened pos_on when ac-
tuatingthe equipment choke control.
H. ThrottleValve
M. ChokeValve
ADJIJSTMENT 25
®
_B41Y_eE5
44
To Next Page
Loading...
Need help?
General
