Domestic Series 7000 MFD
57
9.73. Install the MFD in the tractor as described in the
MFD INSTALLATION section of this manual.
10. TORQUE SPECIFICATIONS
Item Torque SAE Torque Metric Loctite
Ring Gear Bolts 160-220 in-lbs 18-25 Nm 242 blue
Perimiter Bolts (axle housing) 160-220 in-lbs 18-25 Nm 242 blue
Kingpin Housing to Axle Housing 220-280 in-lbs 25-34 Nm 242 blue
Axle Cover 160-220 in-lbs 18-25 Nm 242 blue
Stop Bolts (top of axle housings) 220-280 in-lbs 25-34 Nm 242 blue
Steering Arm to Kingpin Housing 220-280 in-lbs 25-34 Nm 242 blue
Tie Rod End Nuts 49 ft-lbs 66 Nm 242 blue *
Tie Rod End Jam Nuts 360-420 in-lbs 488-570 Nm 242 blue *
Steering Cylinder Stud to Housing 267 ft-lbs 362 Nm 242 blue *
Steering Cylinder Stud Nut 150 ft-lbs 136 Nm 242 blue *
Steering Cylinder Mounting Bracket 75 ft-lbs 100 Nm 242 blue
Axle Mounting Bracket 75 ft-lbs 100 Nm 242 blue
Fill Plug 220-280 in-lbs 25-34 Nm no
Drain Plug 220-280 in-lbs 25-34 Nm no
Pinion Drag (Not tightening troque) 25-30 in-lbs 2.825-3.4 Nm stake
Lug Nuts 55 ft-lbs 63 Nm re-torque*
Notes:
242 blue*: Loctite may be applied if
nylon locking feature is worn.
Replacement preferred.
re-torque*: Re-torque after 10 hrs. of operation.