CDR-3250/80 TECHNICAL MANUAL
3-50 Issue 2.2
Table 3-3 Serial Bus Interface Command Messages.
Message Definition
:NORM Set NORMAL interface mode
:ACKN Set ACKNOWLEDGE interface mode
:IND1 Set INDEPENDENT mode 1
:IND2 Set INDEPENDENT mode 2
:IND3 Set INDEPENDENT mode 3
:? Request Interface Status Message
Table 3-4 Serial Bus Interface Status Messages.
Message Definition
OK:NORM No errors, NORMAL Mode
OK:ACKN No errors, ACKNOWLEDGE Mode
OK:IND1 No errors, INDEPENDENT Mode 1
OK:IND2 No errors, INDEPENDENT Mode 2
OK:IND3 No errors, INDEPENDENT Mode 3
TE:EEPR Testing error - EEPROM corrupted
TE:POST Testing error - power on self test error
LE:PRTY Line error - parity
LE:FRMG Line error - framing
LE:OVRN Line error - overrun
IE:OVFL Interface error - buffer overflow
IE:IVAL Interface error - illegal value
IE:UNKN Interface error - unrecognized message
RE:FALT Radio error - fault has been detected
Courtesy of http://BlackRadios.terryo.org
To Next Page
Loading...