SPECIFICATIONS 3
Culligan
®
Mark 89 and 812 Water Conditioners with Automatic Time Clock or Soft-Minder
®
Meter
1 Capacities and corresponding salt dosages pertain to low hardness waters. Capacities given are per recharge
2 Measured from top of media to top of inlet fitting (backwashed and drained).
3 Measured from top of underbedding to top of inlet fitting.
4 Hardness to iron ratio does not apply and total hardness and iron specifications change as follows when
Sofner-Gard
®
accessory is used: 89 Model - 50 gpg (855 mg/L) total hardness, 10 ppm (mg/L) iron;
812 Model - 75 gpg (1 200 mg/L) hardness, 20 ppm (20 mg/L) iron.
5 Backwash at 120 psi (830 kPa).
6 10 minute backwash, 7 lb (3.2 kg) 89 model or 13 lb (5.9 kg) 812 model salt dosage.
89 Model 812 Model
Control Valve
5-cycle, Reinforced Thermoplastic 5-cycle, Reinforced Thermoplastic
Overall Conditioner Height 51 in 51 in
1 29.5 cm 1 29.5 cm
Media Tank Dimensions (Dia x Ht) 9 x 45 in 12 x 45 in
23 x 114 cm 30 x 114 cm
Salt Storage Tank Dimensions (Dia x Ht) 16 x 43 in 16 x 43 in
41 x 109 cm 41 x 109 cm
18 x 43 in
46 x 109 cm
Exchange Media, Type and Quantity Cullex
®
Media, 0.7 cu.ft. Cullex Resin, 1.4 cu. ft.
Cullex Media, 20 L Cullex Resin, 40 L
Underbedding, Type and Quantity Cullsan
®
Underbed, 20 lb Cullsan Underbed, 30 lb
Cullsan Underbed, 9.1 kg Cullsan Underbed, 13.6 kg
Exchange Capacity 15,400 gr @ 4.0 lb 25,000 gr @ 6.0 lb
@ Salt Dosage Per Recharge
1
998 gr @ 1.8 kg 1 620 gr @ 2.7 kg
21,200 gr @ 7.7 lb 35,900 gr @ 12.0 lb
1 374 gr @ 3.5 kg 2 326 gr @ 5.4 kg
24,200 gr @ 12 lb 42,400 gr @ 18.0 lb
1 568 gr @ 5.4 kg 2 748 gr @ 8.2 kg
Freeboard to Media
2
18.9-19.9 in 17.5-18.5 in
48-51 cm 44-47 cm
Freeboard to Underbedding
3
39.2 in 38.5 in
99.6 cm 98 cm
Salt Storage Capacity 250 lb or 375 lb 375 lb
114 kg or 170 kg 170 kg
Rated Service Flow @ Pressure Drop 7.8 gpm @ 15 psi 8.25 gpm @ 15 psi
Total Hardness, Maximum 50 gpg 75 gpg
1 300 mg/L 1 700 mg/L
Total Iron, Maximum 5 ppm 5 ppm
5 mg/L 5 mg/L
Hardness to Iron Ratio, Minimum
4
8 gpg to 1 ppm 8 gpg to 1 ppm
140 mg/L to 1 mg/L 140 mg/L to 1 mg/L
Operating Pressure 20-125 psi 20-125 psi
140-860 kPa 140-860 kPa
Operating Temperature 33-120°F 33-120°F
1-50°C 1-50°C
Electrical Requirements 120V/60 Hz 120V/60 Hz
Electrical Power Consumption, Min/Max 3 Watts/35 Watts 3 Watts/35 Watts
Drain Flow, Maximum
5
2.0 gpm 3.5 gpm
7.6 L/pm 13.5 L/pm
Recharge Time, Average
6
80 min 85 min
Recharge Water Consumption, Average 45 gal/4 lb 75 gal/6 lb
170 L/1.8 kg 284 L/2.7 kg
Specifications
To Next Page
Loading...
Need help?
General
