Need help?Do you have a question about the Culligan MARK 812 and is the answer not in the manual?
General| Filter Life | 6 months or 500 gallons |
|---|---|
| Operating Temperature | 40 - 100 °F |
| Filtration Technology | Carbon Block |
| Flow Rate | 0.5 GPM |
| Connections | 1/4-inch quick-connect fittings |
| Operating Pressure | 100 psi |
| Type | Under-sink water filtration system |
Information on safety, including notices, cautions, and warnings.
Location details for control valve and media tank serial numbers.
Details on the water conditioner components and shipment.
List of tools and materials required for installation.
Water quality and pressure requirements for proper application.
Guidance on positioning the unit and mounting the control valve.
Connecting the unit to water lines, including bypass and adaptors.
Connecting brine/drain lines and filling the salt container.
Instructions for connecting the Soft-Minder meter leads.
Procedure for adjusting backwash time settings on the timer.
Setting the timer for automatic recharge cycles and the correct time of day.
Setting time clock, salt dosage, and regeneration frequency.
Setting the gallons capacity on the circuit board using dip switches.
Final checks and customer explanation before leaving the installation site.
Diagram illustrating the automatic clock timer wiring.
Diagram illustrating the timer with Soft-Minder meter wiring.
To Next Page
