Cupra BORN 2022 - Steering wheel

Opening and closing
103
Window controls
For the automatic raising function: pull the
button for the corresponding window upwards
until it reaches the second position.
For the automatic lowering function: push the
button for the corresponding window down-
wards until it reaches the second position.
Stop automatic movement: push or pull on the
button of the corresponding window.
Resetting one-touch opening and closing
If the 12-volt battery is disconnected or dis-
charged when the windows are not completely
closed, the electric window automatic raising
and lowering function deactivates and has to
be reset:
●
Switch the ignition on.
●
Close all windows and doors.
●
Pull the corresponding window button up-
wards and hold it in this position for a few sec-
onds.
●
Release the button, pull it up again and hold
it in this position. This resets the automatic
raising and lowering function.
The function can be reset for a single window
or for several windows at the same time.
WARNING
Observe the safety warnings ››› in Intro-
duction on page98.
●
Incorrect use of the electric windows can
result in injury.
●
Never close the rear lid without observing
and ensuring it is clear, to do otherwise could
cause serious injury to you and third parties.
Make sure that no one is in the path of a win-
dow.
●
If the ignition is switched on, the electric
equipment could be activated with risk of in-
jury, for example, in the electric windows.
●
The doors can be locked using the remote
control key. This could become an obstacle
for assistance in an emergency situation.
●
Therefore always take the key with you
when you leave the vehicle.
●
The electric windows will work until the ig-
nition has been switched o and one of the
front doors has been opened.
●
If necessary, use the safety switch to disa-
ble the rear electric windows. Make sure that
they have been disabled.
●
For safety reasons, you should only use
the remote control open and close functions
within about 2 metres of the vehicle. To avoid
injuries, always keep an eye on the windows
when pressing the button to close them. The
windows stop moving as soon as the button is
released.
Note
If the window is not able to close because
it is sti or because of an obstruction,
the window will automatically open again
›››page103. If this happens, check why the
window could not be closed before attempt-
ing to close it again.
Window anti-trap function
The roll-back function reduces the risk of in-
jury when the electric windows close.
If a window encounters resistance or an obsta-
cle when closing, it will reopen immediately
››› .
●
Check why the window does not close.
●
Try closing the window again.
●
If the closing process is interrupted again,
the anti-trap function stops working for a few
seconds.
●
If the window still cannot be closed, it will
stop in the corresponding position. Pulling
the button again within a few seconds closes
the window without the anti-trap function
››› .