Currys Essentials C16LDIB11 - Initial Setup; Turning the TV on for the First Time

GB
Initial Setup
16
HDMI1
USB
PC AUDIO
VGA RF
SCART
Initial Setup
6. Press the
buttons to navigate the menu and change the
settings. Press the OK button to confirm.
OSD Language Select your desired language to be displayed on
the menu. The default on-screen menu language
is set as English.
Country Select the country where you will operate the TV.
The default country is set as UK.
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of the
cable to the RF (75Ω) socket at the rear right side
of your TV.
RF coaxial cable
(not included)
OR
2. Connect the mains adapter to the mains socket after
you have completed all the connections.
3. At this stage, the TV switches to standby mode. The
red LED indicator will illuminate on the front panel of
the TV.
4. In standby mode, press the
button on the right side
panel of the TV or on the remote control to turn the
TV on. The red LED indicator will turn green.
5. The first time you turn the TV on, it will go straight into the First Time
Installation menu. Please ensure the aerial is plugged in and then press
the OK button. (If you have already installed the TV using the Quick Start
Guide, please go to the section “Selecting the Input Source” on the next
page.)
Dansk
Deutsch
Hrvatski
Italiano
OSD Language
OK
Magyar
Nederlands
Norsk
PolskiEnglish
Cesky
E k
Espanol
~
Fran ais
Portugues
Pycck
First Time Installation
Please ensure aerial is plugged in!
Then press OK button.
France
Greece
UK
Australia
Austria
Czech
Denmark
Finland
Country
OK
Belgium
Bulgaria
Croatia
Hungary
Italy
Luxembourg
Germany
Do not connect the TV to the mains supply until
you have completed all the connections.
• Only use the included mains adapter. Do not use
it with any other equipment.
• Always disconnect the TV from the mains socket
when not in use for a long period of time.
• The
button on the right side panel of the TV or
on the remote control is only used for switching
the TV into standby, it does not disconnect the TV
from the mains power. To completely disconnect
the mains power, please remove the mains
adapter from the mains socket.
VIDEO L R Y
Pb
Pr
HDMI2
To the mains socket
Mains Adapter
(included)
C16LDIB11_IB_Running Change_120816_Annie.indd 16 12年8月16日 下午1:58