Curtis Instruments 1212P User Manual

3 — PROGRAMMABLE PARAMETERS
pg. 13
Return to TOC 1212 & 1212P Manual - Sep 2019
3 — PROGRAMMABLE PARAMETERS
e 1212/1212P controllers have a number of parameters that can be programmed using a Curtis
handheld programmer or Curtis PC Programming Station. ese programmable parameters allow
the vehicle’s performance to be customized to best fit the needs of individual vehicle operators.
For information on programmming devices, see Appendix D.
For information on how to use the parameters to optimize performance, see Section 6.
e programmable parameters are grouped hierarchically into menus, as shown in Table 1. Not all
of these parameters are displayed on all controllers; the list for any given controller depends on its
specifications.
Table 1 Programmable Parameter Menus: 1311 Programmer
DRIVE MENU...................................... p. 15
— Accel Max Speed
— Accel Min Speed
— Decel High Speed
— Decel Low Speed
— Rev Accel Max Speed
— Rev Accel Min Speed
— Rev Decel High Speed
— Rev Decel Low Speed
— Key Off Decel
— E Stop Decel
— E Stop Pause
— Soft Start
— Gear Soften
— Creep Speed
— Push Max Speed
— Soft Stop Speed
— Speed................................ p. 17
— Mode 1
— Max Speed
— Min Speed
— Rev Max Speed
— Rev Min Speed
— Mode 2
— Max Speed
— Min Speed
— Rev Max Speed
— Rev Min Speed
THROTTLE MENU............................. p. 18
— Type
— Neutral Input
— PotHigh
— PotLow
— Neutral Deadband
— Throttle Max
— HPD
— Speed Limit Pot
— Throttle Map
— Tremor Suppression
— Calibration
CURRENT MENU............................... p. 21
— Main Current Limit
— Braking Current Limit
— Boost Current
— Boost Time
INHIBIT MENU.................................. p. 21
— Type
— Speed
BRAKE MENU.................................. p. 22
— Delay
— Fault Check
— Hold Voltage
— Brake Light
HORN MENU..................................... p. 22
—
Fault Beep
— Reverse Beep
— Beep Constant
MOTOR MENU.................................... p. 23
— System Resistance
— Resistance Auto Comp
— Auto Comp Current Limit
— Speed Scaler
— Current Rating
— Max Current Time
— Cutback Gain
STALL MENU.................................... p. 23
— Stall Speed
— Stall PWM
— Stall Timeout

Curtis Instruments 1212P Specifications

General

Brand	Curtis Instruments
Model	1212P
Category	Controller
Language	English