Curtis 1232E User Manual

Curtis 1232E/34E/36E/38E & 1232SE/34SE/36SE Manual, os 30
71
24 NOVEMBER 2015
3 — PROGRAMMABLE PARAMETERS: Reset Controller Parameter; Controller Cloning
RESET CONTROLLER PARAMETER
ALLOWABLE
PARAMETER RANGE DESCRIPTION
Reset Controller 0 – 1 Setting this parameter = 1 will reset the controller. This reset is similar to resetting
ResetController 0 – 1 by cycling the keyswitch. Reset Controller has the advantage of resetting without
0x3B05 0x00 causing the parameter block to be reloaded into the 1313/1314 programmer.
CLONING (for copying parameter settings to multiple controllers)
Once a controller has been programmed to the desired settings, these settings
can be transferred as a group to other controllers, thus creating a family of
“clone” controllers with identical settings. Cloning only works between
controllers with the same model number and software version. For
example, the programmer can read all the information from a 1236E-5421
controller and write it to other 1236E-5421 controllers; however, it cannot
write that same information to 1236E-5521 or to 1236SE-5621 controllers.
To perform cloning, plug the programmer (1313 or 1314) into the
controller that has the desired settings. Select the Program menu; follow
the prompts to copy the settings into the programmer.
Plug the programmer into the controller that you want to have these
same settings, and follow the Program menu prompts to write these settings
into the controller.
Note: For cloning Dual Drive controllers, see the separate Dual
Drive manual, p/n 53134-DD.
CAN INTERFACE MENU, cont’d
ALLOWABLE
PARAMETER RANGE DESCRIPTION
Emergency Message Rate 16 – 200 ms Sets the minimum rate between CAN emergency messages from the
CANopen_Emergency_Rate 4 – 50 CANopen Slave system. This prevents quickly changing fault states from
0x3148 0x00  generatingsomanyemergencymessagesthattheyoodtheCANbus.
Suppress CANopen Init 0–1 WhenSuppressCANopenInitisset=1,atKSIOntheinitializationofthe
Suppress_CANopen_Init 0 – 1 CANopen system is suppressed. Typically this is done so that the VCL program
0x3143 0x00 can make changes to the CANopen system before enabling it (by setting the
variable Suppress_CANopen_Init = 0 and running the Setup_CAN() function).

Curtis 1232E Specifications

General

Brand	Curtis
Model	1232E
Category	Controller
Language	English