Why does my CyberPower OLS2000EC/XL say BAT Disconnected/ Battery Replace?
If your CyberPower UPS shows 'BAT Disconnected' or 'Battery Replace', it could be due to missing battery power or a failed battery test. If you are using battery packages, check the battery connector.
What to do if my CyberPower UPS shows O/P Overload?
If your CyberPower UPS indicates an O/P Overload, it means the connected equipment is drawing more power than the UPS can supply. To resolve this, turn off non-essential equipment. If this action solves the problem, the UPS will return to normal operation.
What to do if CyberPower UPS has an Output Short?
If your CyberPower UPS experiences an Output Short, follow these steps: First, shut down the UPS. Then, examine your connected equipment for potential issues by removing them and testing the UPS again.
What to do if my CyberPower UPS is overheating?
If your CyberPower UPS is overheating, shut it down. Then, restart the UPS to check if the fan is working properly and ensure that the ventilation holes are not blocked.
What does High O/P V mean on my CyberPower OLS2000EC/XL?
If your CyberPower UPS displays a 'High O/P V' warning, it indicates that the output voltage is too high. In this situation, shut down the UPS.
What to do for a CyberPower OLS2000EC/XL UPS Charger Failure?
If your CyberPower UPS experiences a Charger Failure, shut down the UPS and turn off the AC input.
General| Wattage | 1800W |
|---|---|
| Topology | Line Interactive |
| On Battery Waveform | Sine Wave |
| Output Waveform | Sine Wave |
| Battery Type | Sealed Lead-Acid |
| Typical Recharge Time | 8 Hours |
| Number of Outlets | 8 |
| Outlet Type | NEMA 5-15R |
| Outlets - Battery & Surge Protected | 8 |
| Outlets - Surge-Only Protected | 0 |
| Form Factor | Tower |
| Input Plug Type | NEMA 5-15P |
| Audible Alarms | Yes |
| Overload Protection | Circuit Breaker |
| Power Capacity | 2000VA |
| Input Voltage | 120V |
| Output Voltage | 120V |
| Output Frequency | 60Hz |
| On Battery Voltage | 120V |
| On Battery Frequency | 60Hz |
| Transfer Time | 4 ms |
| Cord Length | 6 ft |
| Data Line Protection | RJ45 |
| SNMP/HTTP Remote Monitoring | Optional |
| Energy Saving Technology | GreenPower UPS™ Bypass |
Comprehensive safety guidelines for installation, operation, and maintenance.
List of UPS status indicators, alarms, warning, and fault codes with solutions.
Detailed technical data including capacity, input/output, battery, and environment specifications.
Common warning issues, their possible causes, and recommended solutions.
Common fault conditions, their possible causes, and recommended solutions.
To Next Page