52
Installing and Removing the Infant Car Seat
Installing with Base Using Lap Belt Only
8. Press down on SafeLock Belt Tensioner
until it locks into place. If Belt Tensioner
does not lock, try loosening the vehicle
belt slightly, then try to close again.
i
o
9. Grab the Base at the Belt Path and pull
from side to side and front to back to
make sure it is installed correctly. The
Base should not move more than 2.5 cm
(1 inch) in any direction.
If the Base moves too much, open the
SafeLock Belt Tensioner and remove a
little more slack from the vehicle belt,
then close and recheck. After this, if
the Base still moves too much, you
may need to try a different vehicle seat
location or installation method, or both.
To Next Page
Loading...
