CYBEX 625T - Page 161

Connect cables to motor controller
1. Connect the cables to the motor controller.
This includes; the power in (INPUT), display cable (COMM.), elevation cable (INCLINE), drive motor
cable (OUTPUT) and resistor (DB).
Qty.DescriptionItem
1Power In (INPUT)1
1Display Cable (COMM.)2
1Elevation Cable (INCLINE)3
1Drive Motor Cable (OUTPUT)4
1Resistor (DB)5
2. Ensure all cables are connected firmly and securely in their proper place.
Install shield
Using a Philips screwdriver tighten the seven screws securing the shield to the base.
Qty.DescriptionItem
1Base1
7Screws2
1Shield3
Page 161 of 209
Cybex 625T Treadmill Part Number