6. Connect the black cable from the motor controller to the terminal on the line filter.
Install shield
Using a Philips screwdriver tighten the seven screws securing the shield to the base.
Qty.DescriptionItem
1Base1
7Screws2
1Shield3
Install motor cover
1. Place the motor cover into position vertically by aligning the two tabs and four plastic connectors.
Two plastic connectors are mounted in the front cover and two in the motor cover. If motor cover
top does not fit properly, loosen the side screws as needed.
Qty.DescriptionItem
1Motor Cover1
1Front Cover2
2Screws3
4Plastic Connectors4
2. Tighten the two front cover screws using a Phillips screwdriver.
Be sure the screws are securing the motor cover's tabs.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Page 173 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
