Remove line filter
Take notice of which cables are connected to the line filter.
1. Disconnect the two fast-ons connectors that go from the line filter to the motor controller.
Qty.DescriptionItem
1To On/Off Switch (White)1
1To On/Off Switch (Black)2
2Screw3
1Line Filter4
1To Controller (Black)5
1To Controller (White)6
2. Disconnect the two fast-ons connectors that go from the line filter to the On/Off switch.
3. Remove the two screws that hold the line filter to the base plate using a Phillips screwdriver.
Install line filter
1. Place the new line filter in position on the motor base plate.
Qty.DescriptionItem
1To On/Off Switch (White)1
1To On/Off Switch (Black)2
2Screw3
1Line Filter4
1To Controller (Black)5
1To Controller (White)6
2. Install the two screws that hold the line filter to the base plate using a Phillips screwdriver.
3. Connect the white cable from the On/Off switch to the terminal on the line filter.
4. Connect the black cable from the On/Off switch to the terminal on the line filter.
5. Connect the white cable from the motor controller to the terminal on the line filter.
Page 172 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
