Remove back cover
Remove four screws securing back cover to console assembly using a Phillips screwdriver.
Qty.DescriptionItem
1Console Assembly1
1Back Cover2
4Screws3
Remove display board
Repairs and Service. Do not damage the wires or connectors when installing
or removing cables.
1. Disconnect the display board cable from the MCC board connector (J16).
a) Press in the top of the cable connector.
Qty.DescriptionItem
1
DO NOT PULL CONNEC-
TOR OUT BY THE WIRES!
1
1Step a, Latch2
1Step b3
1Step c4
b) Ensure latch disengages the connector.
c) Unplug cable by holding down latch and pulling straight out from connector. Do not pull on wires,
remove by connector.
Page 179 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
