Qty.DescriptionItem
1Console Assembly1
1Back Cover2
4Screws3
Update software
Update software using the following procedure.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
E3 View Monitor
Tools Required:
• Phillips screwdriver
• 11/32” Nut driver
• ESD (Electrostatic Discharge) grounding strap
Disconnect power source
Unplug the power cord from the power outlet.
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Remove back cover
Remove four screws securing back cover to console assembly using a Phillips screwdriver.
Page 181 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
