3. Unplug cables from MCC board by un-latching connectors with the following procedure:
a) Press in the top of the cable connector.
Qty.DescriptionItem
1
DO NOT PULL CONNEC-
TOR OUT BY THE WIRES!
1
1Step a, Latch2
1Step b3
1Step c4
b) Ensure latch disengages the connector.
c) Unplug cable by holding down latch and pulling straight out from connector. Do not pull on wires,
remove by connector.
4. Carefully lift handset assembly and unplug the following cables: contact heart rate grips (J7), handset
membrane (J9) and the ground wire (located under the MCC board).
Qty.DescriptionItem
1Handset membrane (J9)1
1Contact heart rate grips (J7)2
Page 200 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
