CYBEX 625T Service Manual

Error 11: Motion Sensor Defective
Cause:
The motion sensor is reading a consistent value indicative of being unplugged (650-750), or the ground
removed (2100-2900), or power is removed (550-600), or > 3500 (defective) for 10 minutes or greater
during startup.
Use of the motion sensor is disabled outside of Active Mode. Console stores a single Error 11 at the
onset of this condition ONLY. Treadmill is otherwise fully functional.
Service:
• Check the motion sensor cable and connections for damage and replace as needed.
• Read the output value of the motion sensor in Diagnostics to determine the most likely type of failure
(see symptoms above.)
• Test the voltages at the motion sensor connection on the MCC. If OK, replace the motion sensor. If
voltages are inconsistent, replace the MCC and the motion sensor.
Page 75 of 209
Cybex 625T Treadmill Part Number

CYBEX 625T Specifications

General

User Weight Capacity	400 lbs
Speed Range	0.5 - 12.4 mph
Incline Range	0% to 15%
Display	LED
Heart Rate Monitoring	Contact and wireless
Running Area	60" x 20" (152 x 51 cm)