CYBEX Cloud Q User Manual

CENTER SEATING POSITIONS
If your vehicle does not have Lower Anchors in the center seating
position, check your Vehicle Owner’s Manual to see if you are
allowed to use the two inner Lower Anchors from the outboard
seating positions to install a Child Restraint.
CYBEX allows this child restraint to be installed using the two inner
Lower Anchors from the outboard seating positions if the distance
between the inner Lower Anchors is between 11 and 20 inches
(28-51 cm) AND if your vehicle manufacturer allows it. (If distance
is not correct and/or not allowed by vehicle manufacturer, use the
vehicle belt for installation in the center position.)
When using the inner Lower Anchors make sure there are no
obstructions from a buckle stalk for the installation or that the
LATCH straps or mini connectors do not block vehicle belt buckles.
Make sure there is enough height to use the Load Leg in the Center
Seating Position. Many vehicles have a hump in the oor that could
cause the Load Leg, even its shortest position, to push the Base
above the vehicle seat. See page 28.
USING LATCH GUIDES
1. Locate the lower LATCH anchors or the
symbols indicating their location.
2. If the lower LATCH anchors are hidden behind the crease
between the seat back and seat cushion, install the
supplied LATCH Guides to the lower LATCH anchors
for easier installation of the Load Leg Base US.
3. To install, connect the two LATCH Guides to the two
lower LATCH anchors by sliding the LATCH Guides into
the crease and under the lower LATCH anchors.
11-20 in.
26
USING LATCH
EN

CYBEX Cloud Q Specifications

General

Certification	ECE R-44/04, Supplement 7
Mounting type	ISOFIX
Product color	Gold
Car seat group	0+ (0 - 13 kg; 0 - 15 months)
Adjustable backrest	Yes
Belt fastening type	5-point

Weight and Dimensions

Depth	665 mm
Width	440 mm
Weight	5400 g
Height (max)	570 mm
Height (min)	403 mm