EasyManuals Logo

CYBEX Cloud Q User Manual

CYBEX Cloud Q
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
TO REMOVE FROM STORAGE
To install the Base using LATCH, the Connectors must be
removed from their storage compartments.
1. To access the LATCH Connector Storage compartments, squeeze
the Level Adjustment Handle to fully extend the Leveling Foot.
2. Remove each connector by pushing the
red button while pulling out.
3. Lengthen the strap between the connectors using the LATCH
Strap Adjuster located next to the connector on the right-hand
side. Push down on the Adjuster button while lengthening strap.
TO STORE
When using a vehicle belt to secure the Base, the LATCH
Connectors MUST be stored in the Base. Loose Connectors
could seriously injure vehicle occupants in the event of a crash.
1. Fully extend the Leveling Foot and fully extend
the latch strap. Slide each connector back into its
Storage slot until an audible CLICK is heard.
2. Close and Lock the Belt Tensioning Plate.
3. Remove most of the slack from the LATCH strap
by pulling on the LATCH Strap Tensioning Loop
until it lays at on the bottom of the base.
Do not remove more slack from the LATCH Strap than necessary to
allow it to lie at on the bottom of the Base between the Belt Guides.
4. Retract the Leveling Foot by squeezing the Level
Adjustment Handle and pushing in the Leveling Foot.
27
LATCH STRAP
CLICK!
2
2
3
3
1
1
DO NOT OVERTIGHTEN the Latch Strap when storing,
as this will interfere with the Belt Tensioning Plate
when installing the Base using vehicle belts.
REMOVING AND STORING LATCH CONNECTORS

Table of Contents

Other manuals for CYBEX Cloud Q

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYBEX Cloud Q and is the answer not in the manual?

CYBEX Cloud Q Specifications

General IconGeneral
CertificationECE R-44/04, Supplement 7
Mounting typeISOFIX
Product colorGold
Car seat group0+ (0 - 13 kg; 0 - 15 months)
Adjustable backrestYes
Belt fastening type5-point
Weight and Dimensions IconWeight and Dimensions
Depth665 mm
Width440 mm
Weight5400 g
Height (max)570 mm
Height (min)403 mm

Related product manuals